Configure audit webhook using the CLI
This page describes how to set up an HTTP webhook for S3 audit purposes using the CLI.
Using the CLI, you can:
Enable an audit webhook for S3 APIs
Command: weka s3 cluster audit-webhook enable
Use the following command line to enable an audit webhook for the S3 cluster:
weka s3 cluster audit-webhook enable <--endpoint endpoint> <--auth-token auth-token>
Parameters
Name
Value
endpoint
*
The webhook endpoint.
auth-token
*
The authentication token obtained from the webhook service.
Disable an audit webhook for S3 APIs
Command: weka s3 cluster audit-webhook disable
Use this command to disable the audit webhook.
View the audit webhook configuration
Command: weka s3 cluster audit-webhook show
Use this command to view the audit webhook configuration.
Last updated