System congestion
This page describes possible congestion issues in the Weka system.
Last updated
This page describes possible congestion issues in the Weka system.
Last updated
The Weka system is built to be very efficient, provide maximum performance and saturate the network links.
In some situations, the system itself may slow down IOs when reaching some limits (or even block new IOs at higher limits) until the congested resource is relieved. Such situations may be transient and the issue will be resolved on its own after a short time. However, there are also cases that suggest an issue that needs to be addressed, such as a workload maxing out the resources of the cluster. In such cases, the cluster resources must be expanded, as described in Expanding & Shrinking Cluster Resources. Contact the Weka Support Team for more information on this.
The Weka system can issue several types of congestion events/alerts:
Type
Description
Actions
FIBERS
Extreme load of concurrent system operations on a node
This is usually a transient situation due to load on them system. If the load is consistent and the problem persists, add more resources (hosts/cores), as described in or .
DESTAGER
Too many pending IOs are waiting to be written for a specific node
This is usually a transient situation due to load on them system. If the load is consistent and the problem persists, add more hosts to the cluster as described in , or expand the host resources as described in .
SSD
Too many pending IOs to the SSD
If there is a single SSD, it is probably faulty and needs to be replaced. If there are multiple SSDs, the load on the system is too high. To handle such a load, more SSDs should be added to the system, as described in .
RAID_NOT_OK
More IO failures than can be handled have occurred, and IOs cannot be served
Make sure to bring up any host that might be down. If all hosts are up, contact the Weka Support Team.
XDESTAGE
Auxiliary cluster resources are low
This is usually a transient situation due to load on the system. If the load is consistent and the problem persists, add more hosts to the cluster as described in , or consult the Weka Support Team.